Infinity Testing Solutions

Completely Equipped
Lab at Your Service


We are an engineering firm that serves as a testing laboratory and test stands manufacturer

Infinity Testing Solutions| Applications

Testing Service Related applications

  • GDI fuel rail pressure pulsation test

Fuel Rail Pressure Pulsation Test

One of our pressure pulsation test stand applications is for OEM fuel rail component and assembly impulse testing.

With continuously improvement of GDI technologies, the fuel system components are subjected to increased fuel pressure. The cyclic pressure fatigue life of the fuel rail component and assembly becomes a critical factor of quality control. This type of testing requests high pressure and high cycle frequency in order to obtain test results in a reasonable time span. The test system must be capable of running tens of millions of cycles continuously without compromising its performance.

The following key features make our pressure impulse test stand ideal for this application:

  • Specified calibration fluid can be used as test medium
  • High pressure amplitude and high cycle rate
  • Tight tolerance peak pressure control
  • Automatic specimen failure detection and stopping
  • Extended pressure generator seal life

In house pressure pulsation testing services are also provided at ITS for client's needs.

  • RMI Standard Section 9.6 Beam to column connection cyclic test

RMI Connection Cyclic Test at ITS

Infinity Testing Solutions developed dedicated rack connection cyclic test apparatus in accordance with RMI Specification, Section 9.6, and performed extensive amount of testing for rack manufacturers and engineering consulting firms. 

The rack column and beams are installed in horizontal orientation for maximum support rigidity. Two servo-hydraulic actuators were utilized to apply rotation and moment load at each beam end. The actuators were controlled for equal rotation at each beam end. The applied loads and beam end position was continuously measured during cycle test.

A constant axial compression load was applied on the rack column by a hydraulic cylinder simulating beam load from upper levels. Two small hydraulic cylinders were installed on the beam top surface. A force was applied at each side of the beam simulating pallet loads on the connector under test.

ITS developed computer control program for RMI connection cyclic test to perform the predetermined test cycles precisely and automatically.

We conduct a full range of rack structural testing according to RMI Specification. A detailed test report, signed by a professional engineer, is included as standard services.

Product Related applications

  • GDI fuel rail pressure pulsation test

Fuel Rail Pressure Pulsation Test

One of our pressure pulsation test stand applications is for OEM fuel rail component and assembly impulse testing.

With continuously improvement of GDI technologies, the fuel system components are subjected to increased fuel pressure. The cyclic pressure fatigue life of the fuel rail component and assembly becomes a critical factor of quality control. This type of testing requests high pressure and high cycle frequency in order to obtain test results in a reasonable time span. The test system must be capable of running tens of millions of cycles continuously without compromising its performance.

The following key features make our pressure impulse test stand ideal for this application:

  • Specified calibration fluid can be used as test medium
  • High pressure amplitude and high cycle rate
  • Tight tolerance peak pressure control
  • Automatic specimen failure detection and stopping
  • Extended pressure generator seal life

In house pressure pulsation testing services are also provided at ITS for client's needs.

We provide expert

and quick testing solutions!